Avalon Firestyles Fireplace Insert Wiring Kit - Manual (Page 4)

Wiring Kit, Gas & Pellet Inserts
97200315
Page 4 of 6 17601371 – 1/31/2014 © Travis Industries, Inc.
Pellet Insert Installation (continued)
2. Remove the power cord following the directions below.
Use pliers to compress the
strain relief from the top and
bottom while pulling it out of
the hole in this bracket.
Remove the power cord.
3. Pre-thread the backing plate.
Pre-thread the backing plate - remove
the screw after the plate is threaded.
5/16" Nutdriver
4. Attach the conduit to the mounting bracket as shown below.
Locknut
Conduit
Mounting Bracket
Tighten the locknut to
secure the conduit to the
mounting bracket as shown.