Avalon Firestyles High-Temperature Wood Insert Wiring Kit - Manual (Page 4)

High-Temperature Wood Insert Wiring Kit
97200337
Page 4 of 6 1/31/14 - 17601776 © Travis Industries, Inc.
Installation – Flush Wood Inserts (Small, Medium, Large)
NOTE: The wiring kit may be routed to the left or right side of the insert. An additional knockout is provided on
the right side to allow the wiring kit to be routed through the side wall.
1 Disconnect the molex connector from the power cord as shown below.
Disconnect the molex connector
leading from the power cord.
Power Cord
Rheostat Wires
2 Remove the power cord as shown below. Tighten the strain relief on the two wires leading to the rheostat.
Unscrew the clamp
on the strain relief.
Remove the
power cord.
Tighten the clamp to secure the
wires leading to the rheostat.