Avalon Firestyles GreenStart Igniter 2 for Inserts User Manual
Page 5
GreenStart Igniter 2 for Inserts:
Installation Instructions
(SKU 94400952)
Page 5 of 12
17601768.docx— 10/21/13
© Travis Industries, Inc.
Start Button Installation
Flush Wood Plus Arch Start Button Installation:
Drill a
9
/
64
” pilot hole approximately 2” from the flat end of the left side trim panel. Enlarge the hole with
the ½” drill bit.
Affix the GreenStart sticker over the hole.
Route the On/Off switch wires through the drilled hole and install the power button.
Attach the trim and panels, and connect the start button wires to the igniter assembly.
NOTE: The wires are color-coded and must be matched.
Flat End
Beveled End
NOTE:
Use a saw to remove a
7/8” x 7/8” notch from
the rear of the trim. This
will be used to route the
igniter cord.