Avalon Firestyles AGP Pellet Insert - Manual (Page 6)

ZC Kit – AGP Pellet Insert
(94400157)
Page 6 of 10 17601823 - 3/7/14 © Travis Industries, Inc.
ZC Can Construction
The zc can is shipped flat. Construct the zc can and stand-offs as shown below. Use the included screws to
secure the standoffs and zc can sides/top to the zc can rear panel.
After the zc can is constructed the top or rear knock-out should be removed to allow vent to pass through.
WARNING: The sheet metal edges are sharp.
Use gloves when handling the zc can.
Top of ZC Can
Knock-out for top
vent applications
A knock-out is provided on the rear panel
for rear vent applications.
Bend the mounting flanges as shown.
NOTE:
The rear screws install from the outside.
NOTE:
The front screws install from
the inside.
a b c
Attach both rear stand-offs to
the zc can rear panel.
ZC Can
Rear Panel
d
Bend both rear stand-offs as shown above.