Avery Dennison Monarch 9864 Error Messages - Manual (Page 42)

05/08 Rev. AB USER MANUAL Error Messages
9844 – 9854 – 9864
42
5121 Touch down
Status The applied applicator does not reach the Touch Down Position. It extends
completely without reaching any product or other resistance.
Preconditions for this error to occur:
• The parameter
DP INTERFACE > Interface type
is set to USI Applicator.
• Internal inputs are enabled.
Action Correct the applicator position. The applicator must reach the product
before it is completely extended.
Press Online to acknowledge.
5122 PLC not ready
Status The connected PLC is not on line.
Preconditions for this error to occur:
• The parameter
DP INTERFACE > Interface type
is set to USI Applicator.
• Internal inputs are enabled.
Action Check if the PLC is powered on.
Check if the PLC shows any error status.
Press Online to acknowledge.