Avery Dennison Monarch 9864 Error Messages - Manual (Page 48)

05/08 Rev. AB USER MANUAL Error Messages
9844 – 9854 – 9864
48
5522 Tag write err
Status A transponder (tag) cannot be written on for one of the following reasons:
• Faulty address: attempted to write a protected area.
•
The tag is recognized but out of the antennas reach.
• Noise signals interfere with the transmission.
Action Check the system for the error causes and correct them.
5523 Tag address err
Status Faulty address: The address is beyond the logical or physical address
range of the transponder.
Action Change the address.
5524 CMD not applicable
Status A command cannot be interpreted by the transponder.
Action Change or remove the command.
5525 Tag read err
Status A transponder (tag) cannot be read for one of the following reasons:
• The tag is recognized but out of the antennas reach.
• Noise signals interfere with the transmission.
Action Check the system for the error causes and correct them.
5526 Tag select first
Status A read or write command was given without selecting the transponder at
first.
Action Add a select command before using the read/write command.
5527 Tag RF comm err
Status Transponder and reader are unable to communicate for one of the following
reasons:
• More than one transponder is within the antennas reach.
• No transponder is within the antenna's reach.
Action Check the label material feeding. Remove a paper jam.
5528 EEPROM failure
Status • The reader cannot write on the transponder EEPROM.
• A faulty checksum was detected before writing on the EEPROM.
Action Repeat the writing attempt.
Try another transponder.