Avery Dennison 9850 RFID Multi-Protocol - Manual (Page 15)

Multi-Protocol Encoding 2-3
U s i n g t h e R F I D S e t u p M e n u
Use the RFID Setup Menu to Read a tag, set the number of Write
Attempts, Read Power, Write Power, Clear Data, print an RFID
Configuration label, and select a different Protocol.
MAIN MENU
Option Choices Default
Read Tag NA NA
Write Retries 1-5 3
Signal Adjust 0-6 2
RF Power Read Power 1-27/Write Power 1-27 18
Clear Data Yes/No No
Print Config Yes/No No
Protocol Class1 96/Class1 64/UCODE/Impinj 0+/
Matrics DEMO/Gen2 Class1 96
When you turn on the RFID printer, “Monarch Initializing” flashes briefly
and then you see “Print Mode Ready.” If an error occurs while the printer
is initializing, the error message flashes briefly on the display and then
you see “Print Mode Ready.” The printer displays “Not available” when
you try to select the RFID menus if the module is inoperative.
The printer accepts RFID and non-RFID batches once you see “Print
Mode Ready.”
Read
Tag Clear
Data Signal
Adjust Print
Config Write
Retries RF
Power
Setup
RFID
Protocol