Avery Dennison 9850 RFID Multi-Protocol - Manual (Page 18)

2-6 Multi-Protocol Encoding
Signal Adjust
Use the Signal Adjustment to increase the strength of the RF Field
emitted by the printer’s antenna. The higher the value, the greater the
power of the RF Field.
If the Read Power is set too low or too high, the RFID tag in the RF field
may not be read.
CAUTION
Use extreme caution when changing the Signal
Adjustment because the RFID tags may become non-
functional!
To change the setting, from the Main Menu, select Setup, then RFID.
Then follow these steps.
1. Press or until you see
RFID
Signal Adjust
2. Press Enter/Pause. The current setting is displayed, for example:
SIGNAL ADJUST
[0/6]: +2
3. Press or to increase or decrease the setting. After you display
the option you want, press Enter/Pause.
4. Press Escape/Clear until you see the Main Menu.