Aviosys 9216 - Manual (Page 7)

IP SENSOR 9216 USER MANUAL
8. Setting the buzzer
User can turn off the buzzer in setup webpage, then buzzer will not alarm . User can turn off the alarm in one
onitoring item, so when this monitoring item reach the alarm level , 9216 will not alarm. When one or multiple
ger the alarm, you can cancel the alarm by pressing the alarm reset button, but when these
m again.
isplay from left to right :
,
F2 , 3
times), it means the IP address of 9216 is 192.168.10.100 : 50.
ltage.
T1 T2 T3: means following will display the temperature values of 3 route monitoring temperature(in degree
centigrade, C)
F1 F2 F3: means following will display the rotate speed of 3 route monitoring fan.
m
monitoring item trig
monitoring item reach the alarm level again, the buzzer will make an alar
9. LED display
9216 can display its working state through the digital LED, for example:
D
IP , 192 , 168 , 100 , 99 , 80 , P1 , 3.00, P2, 0.03 , P3 , 2.00 , T1, 29 , T2 , -48 , T3, -48, F1, 3824
633 , F3 , 0 .
* IP : means following will display the IP address of 9216. IF following displays 192, 168, 10, 100 : 50 (in 5
* V1 V2 V3 : means following will display the voltage values of 3 route monitoring vo
*
*
2. Specification
9216E package contents
One 1A, 110~220V power adapter
2 temperature sensors
3 voltage sensor wires
One set of 9216
Minimum System Requirements
Intel Pentium III 300MHz or above/compatible AMD CPU
ork card with RJ45 port & Ethernet HUB or Switcher
Internet network (Ethernet, ADSL or other ways, depends on whether you need far end control ability or
not)
WINDOWS operating system (IE5.0+SPI) & LINUX
Minimum 64MB RAM
VGA Card: supported direct draw
Netw
- 6 -