Baby Lock Ellegante 3 (BLG3) Instruction and Reference Guide Addendum - Manual (Page 13)

11
E
NGLIS
H
m
Remove the appliqué material from the
embroidery frame, and then carefully cut
along the stitching. After cutting, carefully
remove all of the cutting line thread.
n
Use two layers of adhesive water-soluble
stabilizer material with their sticky sides
together, and then hoop them in the
embroidery frame.
o
Thread the machine with the thread for the
outline from step
q
, and then sew the
placement line for the appliqué position
(APPLIQUE POSITION).
a Pattern placement line
p
Lightly apply glue or spray adhesive, and
paste the appliqué piece so that it aligns with
the placement line.
q
With the machine threaded using the thread
for the outline from step
o
, sew the outline
(APPLIQUE).
a Outline of appliqué piece
r
After embroidering is finished, remove the
stabilizer material from the embroidery
frame.
Note
• Depending on the pattern density and fabric used,
there may be shrinking of the pattern or the appliqué
may be misaligned with the placement line. We
recommend cutting slightly outside of the cutting
line.
• When using patterns that are vertically and
horizontally symmetrical, use a chalk pen to indicate
the pattern orientation before cutting it out.
• Carefully cut out the pattern on the outline you just
sewed. Do not cut inside the cutting line, otherwise
the appliqué fabric will not be caught by the appliqué
stitch.
Note
• If water-soluble stabilizer is used, it is not necessary
to remove the stabilizer material after sewing the
appliqué outline. To reduce shrinkage of the pattern,
we recommend using water-soluble stabilizer.
• Put together two layers of water-soluble stabilizer,
otherwise the stabilizer material may tear during
embroidering.
Note
• Before pasting the appliqué piece down, make sure
the appliqué piece is positioned correctly within the
placement line.
Memo
• The outline is sewn using satin stitching.
• Some glue may get onto the presser foot, needle,
and needle plate at this time. Finish embroidering
the appliqué pattern, and then clean off the glue.