Desa 107624-01 - Manual (Page 9)

9 107705 www.desatech.com
ENGLISH
ASSEMBLY
Note: Some models are pre-assembled. Assembly
is not needed on these models.
See Saw Chain Tension Adjustment, pages 8 and 9.
1. Lay chain out flat.
2. Loosen and remove guide bar nuts and sprocket
cover.
3. Loosen and remove drive sprocket screw or re-
move E-ring from shaft (see Figure 4). Remove
sprocket support.
WARNING: Cutting edges on chain
are sharp. Use protective gloves when
handling chain.
IMPORTANT: Do not clamp chain saw in
vise during assembly.
Continued
Switch Linkage This device connects switch to trig-
ger. It moves switch when you squeeze trigger.
Switch Lockout Device that reduces accidental start-
ing of saw.
Trigger Device that turns saw on and off. Squeezing
trigger turns saw on. Releasing trigger turns saw off.
Trimming (Pruning) Process of cutting limb(s) from
a living tree.
Undercut An upward cut from underside of log or
limb. This is done while in normal cutting position
and cutting with top of guide bar.
CHAIN SAW NAMES AND
TERMS
Continued
4. Install guide bar onto saw body. Assemble cen-
ter slot of guide bar onto guide bar bolts.
5. To replace sprocket support, repeat step 3 in re-
verse order. Firmly tighten drive sprocket screw
with #2 Phillips screwdriver (if applicable).
6. Place chain around drive sprocket, along top
groove of guide bar, and around guide bar nose.
Note: Make sure cutting edges of chain are fac-
ing in right direction. Position chain so cutting
edges on top of guide bar face guide bar nose (see
Figure 4, and indicator on side cover of saw).
CAUTION: Do not place chain on
saw backwards. If chain is backwards,
saw will vibrate badly and will not cut.
7. Insert tab of sprocket cover into slot on side cover
and rotate sprocket cover onto guide bar bolts until
sprocket cover rests against guide bar.
8. Place guide bar nuts, removed in step 2, over
guide bar bolts.
IMPORTANT: Tighten guide bar nuts finger
tight only.
9. Turning thumbscrew (Model 107625-01, -02,
111174-01) or tensioner screw (Model 107624-
01, -02), adjust position of nib until it is aligned
and inserted into the round adjusting hole on guide
bar (see Figure 4 and Figures 5 and 6, page 8).
Turning thumbscrew or screw counterclockwise
will move tensioner bar to rear of guide bar. Turn-
ing thumbscrew or screw clockwise will move
tensioner bar to front of guide bar.
10. If needed, readjust guide bar nuts to finger tight only.
11. Adjust saw chain tension. Follow steps under
Saw Chain Tension Adjustment, pages 8 and 9.
Guide Bar Nuts
Sprocket Cover
Drive Sprocket Screw or E-Ring
Sprocket Support Guide Bar Bolts
Saw Chain
Guide Bar
Drive Sprocket
Cutting Edge
Figure 4 - Assembling Guide Bar and Chain
Adjusting Hole
Towards Guide Bar Nose
107705-01 12/16/03, 4:07 PM 9