Diamond Power Products DL 5000 - Manual (Page 7)

DL5000 INSTRUCTION MANUAL PAGE 6 -
Troubleshooting
Problem: Blade jammed in work material.
Cause:
Twisted blade from forcing work materials into the blade.
Solution: Before freeing any jammed materials, immediately turn OFF power switch and wait until all moving
parts have stopped. Gently free work material, holding blade against the blade guides to prevent it from stretching
or badly twisting. Back out of the cut if needed. Inspect blade for kinks and ensure there is no remaining debris
in the blade path which may have caused the jam.
Problem: Saw runs slowly or stops while cutting
Cause:
Drive belt slippage or broken.
Solution: See Band Saw Use and Maintenance Drive Belt Tension-Section A.
Additional Parts
Item Item Number
DL5000 TABLE P500
DL5000 MAIN FRAME P501
DL5000 VARIABLE SPEED CONTROL 110V/220V P502/P502A
DL5000 WHEEL SET P503
DL5000 DRIVE BELT P540
DL5000 UPPER BLADE BLOCK P542
DL5000 LOWER BLADE BLOCK P543
DL5000 DRIVE HUB ASSEMBLY P544D
DL5000 NON-DRIVE HUB ASSEMBLY P544ND
DL5000 STAINLESS STEEL BLADE - TILE 16
DL5000 STAINLESS STEEL BLADE - GLASS 47
DL5000 BLADE GUIDE SET 34
Blade Repair Service
Diamond Tech offers a blade repair service should a blade break with ample diamond remaining. Return
blade, indicating saw model and payment to Diamond Tech, Blade Repair Service, 5600 Airport Blvd.,
Suite C,Tampa, FL 33634. For International and special handling, please include extra postage and
shipping instructions
Blade Repair Fees (U.S. Dollars):
Speedster, DL1000, DL3000........................................................................ $25.00
DL5000......................................................................................................$45.00
DL7000......................................................................................................$78.00