Baumatic BHS600.5SS - Manual (Page 14)

14
i
e rise of 100°C above the
ambient temperature of the room it is located in,
depending on size) or 600 mm worktop that is at least 30
m thick. The following minimum clearance distances must be
o
700 mm between the hob surface and the underside of any
o
50 mm clearance between the back of the hob surface and the
f a kitchen unit. There must
be a gap of at least 150 mm between the side of the hob and the
kitchen unit.
hen unpacking the appliance please check that the following items
hin the packaging:
d instruction manual
fixing brackets
Sealing strip
Position
ng
The adjacent furniture must be able to withstand a
minimum temperatur
during periods of use.
This appliance is classified as Class 3 and therefore is to be built into a
kitchen unit (
m
observed:-
horizontal surface above it.
o
50 mm clearance around the sides and front of the appliance.
wall behind it, measured from the cut-out.
o
If the hob is positioned so that the right or left hand side of the
appliance will be near to the edge o
vertical surface of the
Unpacking the appliance
W
are contained wit
1 Baumatic hob
1 Installation an
1 Guarantee card
4 Fixing screws
4
1