Baumatic BHC310 - Manual (Page 26)

o
Fasten the bracket to the position on the hob with a screw.
Adjust the bracket position to suit different table top thicknesses.
o
Place the long screw into the fixing hole on the outer edge of the
bracket but do not fully tighten.
o
Carefully turn the hob back over and then gently lower it into the
aperture hole that you have cut out.
o
When the hob is correctly positioned, tighten the long screws to
fix the hob securely in the aperture hole. These screws MUST
be securely tightened.
Electrical connection
YOUR HOB IS INTENDED FOR FITTED AND
PERMANENT INSTALLATION.
o
Cable type: H05 RRF 3 core x 1.50 mm³ (Type RR-F <HAR>
marked). (not supplied)
o
Before connecting the appliance, make sure that the supply
voltage marked on the rating plate corresponds with your mains
supply voltage.
o
We recommend that the appliance is connected by a qualified
electrician, who is a member of the N.I.C.E.I.C. and who will
comply with the I.E.E. and local regulations.
o
WARNING: THIS APPLIANCE MUST BE EARTHED.
o
The hob must be wired into a 20A double pole switched fused
spur outlet, having 3 mm contact separation and placed in an
easily accessible position adjacent to the appliance. The spur
outlet must still be accessible even when your hob is located in
its housing.
o
The wiring in the mains lead is coloured as follows:
Brown
Live
Blue Neutral
Green and yellow Earth
o
As the colours of the wires in the appliance’s mains lead may not
correspond with the coloured markings identifying the terminals
in your spur box, please proceed as follows:
26