BayTech PDU Single Phase - Manual (Page 4)

4
INSTALLATION
UNPACKING
Compare the unit and serial number of the equipment you received to the packing slip located on the
outside of the box. Inspect equipment carefully for damage that may have occurred in shipment. If
there is damage to the equipment or if materials are missing, contact BayTech technical support at 228-
563-7334 or call toll free inside the United States at 800-523-2702. At a minimum, you should receive
the following:
1. The PDU unit.
2. Rack mounting Kit
NOTE: Keep the shipping container and packing material in the event future shipment is
required.
PREPARING THE INSTALLATION SITE
The installation area should be clean and free of extreme temperatures and humidity. Allow sufficient
space behind the PDU unit for cabling and receptacle connections. Access to installation site should be
restricted to authorized personnel. Installation of these units should be limited to ITE and Telco server
environments.
POWER
• 115 VAC Model: Internal 115 VAC 60 Hz
(15, 20 or 30 Amps Maximum Load).
• 230 VAC Model: Internal 230 VAC 60 Hz
(10, 16, 20 or 30 Amps Maximum Load).
CAUTION: This unit is intended for indoor use only. Do not install near water or expose this
unit to moisture. To prevent heat buildup, do not coil the power cords when in use. Do not use
extension cords. Do not attempt to make any internal changes to the power source. Do not
attempt to modify any portion or component of a PDU Series Unit unless specifically directed
to. BayTech must perform any internal operations.
CAUTION: High-voltage surges and spikes can damage this equipment. To protect from
such power surges and spikes, this unit must have a good earth ground.
CAUTION: Before removing or replacing any cables or power cords, unplug both power
supply cords located on the PDU Series Unit. Communication to the unit will be disrupted
while power is off.
CAUTION: Do not exceed the AC current rating for the selected model. Both power sources
have to be of identical nature in such a way that there is no phase differential between the
supplying sources
CAUTION: In order to be isolated, the feeding power cords must be detached from the unit.