BayTech RPC Single-phase Conbined QS - Manual (Page 14)

RPC with or without Ethernet
13
Help Menu:
Type Help followed by a <CR> to view the line commands for the RPC’s.
Figure 2
Password setting: Once you have logged out and log back in as a user or as the administrator, you
can then set the password to gain access. Type “Password”<cr>
Figure 3
Power Controller Configuration Menu:
To select the configuration menu, type ‘config’ at the prompt.
NOTE: If the unit display with the following message, “Configuration mode in use” A user
in the other port is in the “Configuration” menu.
RPC>help
On n <cr> --Turn on an Outlet, n=0,1...20,all
Off n <cr> --Turn off an Outlet, n=0,1...20,all
Reboot n <cr> --Reboot an Outlet, n=0,1...20,all
Status <cr> --RPC-28 Status
Config <cr> --Enter configuration mode
Lock n <cr> --Locks Outlet(s) state, n=0,1...20,all
Unlock n <cr> --Unlock Outlet(s) state, n=0,1...20,all
Current <cr> --Display True RMS Current
Voltage <cr> --Display True RMS Voltage
Power <cr> --Display Average Power
Clear <cr> --Reset the maximum detected current
Temp <cr> --Read current temperature
Logout <cr> --Logoff
Logoff <cr> --Logoff
Exit <cr> --Logoff
Password <cr> --Changes the current user password
Whoami <cr> --Displays the current user name
Unitid <cr> --Displays the unit ID
Type Help for a list of commands
Enter Request:
RPC>password
Enter new Password: *****
Re-Enter new Password: *****
Type Help for a list of commands
RPC>