Becker TRAFFIC ASSIST 7926 - Manual (Page 60)

60
>>> NAVIGATIONAL MODE
> D
> GB
> F
> I
> E
> P
> NL
> DK
> S
> N
> FIN
> TR
> GR
> PL
> CZ
> H
> SK
If dynamic route guidance is active, a con-
tinuous check is made for the presence of
relevant announcements for the selected
route (however, traffic problems still ap-
pear on the map even when route guid-
ance is not active).
If these continuous checks determine that
a traffic announcement is relevant to route
guidance, the unit will automatically re-
calculate a new route to the destination
(See “The TMC button*” on page 56.).
Displaying TMC messages on
the map*
Current TMC messages are displayed on
the map in graphic form. Sections of the
route where there are problems with traf-
fic are highlighted green. An orange ar-
row continues to be displayed, which in-
dicates the traffic direction which is
affected by the holdup.
In addition to the coloured mark, a warn-
ing sign is displayed on the stretch of road
affected.
Using TMC*
Once you have connected the TMC an-
tenna, your Traffic Assist will receive cur-
rent traffic announcements and dynamic
route calculation will be enabled (traffic
jam diversion). You can also view traffic
announcements directly.
To preset the TMC, See "The TMC but-
ton*" on page 56.
> In the map display, activate the (see also
page 64) toolbar and press .
or
> In the main menu, press
TMC (see also
page 26).
Note:
As the traffic announcements are trans-
mitted by radio stations, we cannot as-
sume responsibility for the completeness
or accuracy of the announcements.
Austria: The location and event code was
made available by ASFINAG and BM-
VIT.
Note:
The button only becomes visible once
you have switched to navigation mode
and then called up the main menu again.
After switching the Traffic Assist with
TMC off and on again via the On/Off
switch, the
TMC button is only visible
following the procedure described above.
*Applies only to the Traffic Assist with TMC