Desa BHDV41N/P - Manual (Page 25)

25 105540
OWNER’S MANUAL
1
2
3
WARNING: The glass door
must be securely in place before
running this fireplace. Do not run
this fireplace if glass is missing
or broken.
FIREPLACE
INSTALLATION
Continued
Figure 53 - Installing Log No. 1
Figure 54 - Installing Log Assembly No. 2
Figure 55- Installing Log Assembly No. 3
Figure 56 - Placing Ember Material on
Burner
Ember Material
Fireplace Models
HDV37N/P(A,B) and
HDV41N/P(A,B)
1. Place log#1 (back log) on grate. Make
sure the lower middle section of the log
fits securely into the open area in back
of grate (see Figure 53).
2. Place log #2 (two log assembly) onto pins
on left front and middle section of the front
burner (see Figure 54).
3. Place log #3 (crossover assembly) onto
the front right pin on front burner with
the crossover log resting in notch on
back log (see Figure 55).
4. Place lava rock along sides and front of
firebox bottom.
NOTICE: Do not put lava rock on
burner or under burner. Placing
lava rock on burner could cause
performance problems.
It is not necessary to use all of the lava
rock provided.
5. Pull ember material apart into pieces
no larger than a dime. Place these
pieces loosely onto the exposed section
of the front burner and space between
logs 2 and 3 where front burner is ex-
posed (see Figure 56). This will create
the glowing appearance as the flame
touches the ember material. Do not
block ports by using too much ember
material in one area. It is not necessary
to use all of the ember material pro-
vided.
7. Replace the glass door. See Removing/
Replacing Glass Door, page 22.