Belshaw Adamatic HI18 Econo-Icer - Manual (Page 19)

Belshaw Bros., Inc. • www.belshaw.com • Phone 206-322-5474 • Fax 206-322-5425
Econo-Icer HI18 & HI24 TS MN-1748EN 1
1 Maintenance
Wire Tensioning and
Replacement.
Tools Required:
(2)
5/16” Open End Wrench
(1) Wire Cutter
NOTE:
Do not use a box wrench to tighten. This
will cause too much torque and frame may
bend and bow
1. Place looped end of wire over the “Wire
Retainer Pin” (HI18-0004) placing it in the
groove.
2. Thread other end of wire through the hole in
the “Wire Adjusting Pin” (HI24-0020) and
bend the end pointing up as shown.
3. With the 5/16” open-end wrench, loosen the
#10-32X1” machine screw.
4. With the 5/16” open-end wrench, turn the
“Wiring Adjusting Pin” to tighten the wire.
Be sure the wire winds in the groove of the
pin. (This will also tighten the loop around
the “Wire Retainer Pin”).
5. Tighten the wire until taut, removing all
slack. DO NOT OVER TIGHTEN!
OVER TIGHTENING WILL CAUSE
THE FRAME TO BEND AND BOW.
6. Tighten the #10-32 machine screw to hold
pin in place.
7. Trim excess tail of the end of wire with
wire cutters.