Daewoo DR-C913B - Manual (Page 10)

9
Product
Information Identification of Controls
Rear Panel
! Power Cord
Jack for supplying power to the unit. Connect to a
wall outlet.
@ 5.1 Speaker Out Jack
Connect each of the speaker wires to the satellite
speakers. Speaker cords, 1 for each speaker, are
needed for connection. When connecting the
speakers, make sure the polarities ("+" side of the
speaker wire to "+" on the receiver) of speaker
wires and terminals are matched.
# Connection to Antenna Cable
Connect a coaxial cable from your cable wall
outlet or antenna to the ANT IN jack on the back
of your DVD/VCR unit.
$ AM Antenna Jack
% S-Video Output Jack (DVD only)
^ COMPONENT (Progressive) Out Jack (DVD
only)
To obtain better screen quality, connect the unit
to a TV or monitor with a COMPONENT(480i or
480p) input.
Note: VCR signal is only available from Composite Video
Out jack and RF Out. You must always connect these to
the TV in order to set up and use your unit.
& Subwoofer Pre-Output Jack
Connect an active subwoofer to improve bass
performance especially in a large room.
* A/V Output Jack
( A/V Input 2 Jack
) A/V Input 1 Jack
1 Connection to TV
Required connection for VCR operation. Connect
one end of the RF cable to the RF Out Jack on the
back of the unit and the other end to the ANT IN
jack on the back of your TV.
2 FM Antenna Jack
@ ! # $
% & *() 1 2 ^
DR-C91/92D1N-BS 04.1.19 9:51 PM ˘ ` 9