Bematech MP-4000 TH Programmer's Manual - Manual (Page 72)

MP-4000 TH POS Printer Rev.1.4 Programmer’s Manual
22-aug-2007
Firmware Release: 1.5 72
• This command is executed even when the printer is offline, the
receive buffer is full, or there is an error status with a serial interface
model.
GS I n
[Function] Transmit printer ID.
[Format]
ASCII GS I n
Hexadecimal 1D 49 n
Decimal 29 73
n
[Description]
Transmits the printer ID specified by n as follows:
n Printer ID Specification ID (hexadecimal)
1, 49 Printer model ID TM-T88II series 20
2, 50 Type ID See table below.
3, 51 ROM version ID Depends on ROM version.
65 Firmware version Depends on Firmware version.
66 Manufacturer BEMATECH
67 Printer name MP-4000
68 Serial number Depends on serial number.
69 Type of model INTERNATIONAL
n = 2, Type ID
Bit Off/On Hex Decimal Function
Off 00 0 Two-byte character code not supported. 0
On 01 1 Two-byte character code supported.
1 On 02 2 Autocutter equipped.
2 Off 00 0 Not used. Fixed to Off.
3 Off 00 0 Not used. Fixed to Off.
4 Off 00 0 Not used. Fixed to Off.
5 - - - Undefined.
6 - - - Undefined.
7 Off 00 0 Not used. Fixed to Off.
[Details]
• The printer ID is transmitted when the data in the receive buffer is
developed. Therefore, there may be a time lag between receiving this
command and transmitting the status, depending on the receive buffer
status.
• When the printer ID transmission is specified with (1 = n = 3) or (49 = n =
51), one byte code is transmitted.
• When Auto Status Back (ASB) is enabled using GS a, the printer ID
transmitted by GS I and the ASB status must be differentiated using the table
in Appendix III.