DeLonghi Fully Automatic Coffee Center Machine ESAM6700 - Manual (Page 15)

14
required level, press the icon again.
The quantity set has now been programmed.
Information: This setting is valid for mak-
ing both one and two cups. You cannot program
a quantity for two cups. To obtain 2 quantities of
“my coffee” press the
button.
programming the long “my coffee” quantity
The appliance is set by default to automatically
deliver ≃ 3.4 oz of LONG coffee. To modify this
quantity, proceed as follows:
1. Press the icon repeatedly (fig. 8) until
“MY COFFEE” is displayed.
2. Press the LonG icon (fig. 10) until “Pro-
gram quantity” is displayed, then release.
The machine starts delivering the coffee and
the LonG icon flashes.
3. As soon as the coffee in the cup reaches the
required level, press the LonG icon again.
The quantity set has now been programmed.
regulating the coffee mill
The coffee mill is preset in the factory to prepare
coffee correctly and should not require regulating
initially.
However, if after making the first few coffees
you find that delivery is either too fast or too
slow (a drop at a time), this can be corrected
by regulating the grinding adjustment knob (fig.
11).
Important! The grinding coarseness
regulator must only be turned when the coffee
mill is in operation (when you hear the grinder
in motion).
For slower coffee delivery
and a creamier coffee, turn
one click towards “1” (finer
ground coffee).
For more rapid coffee deliv-
ery (not in drops), turn one
click towards “7” (coarser
ground coffee).
Information: These adjustments will only
be evident after at least two cups of coffee have
been made.
making espresso coffee using coffee beans
Important! Do not use caramelized or
candied coffee beans as they could stick to the
coffee mill and make it unusable.
1. Fill the container with coffee beans (fig. 12).
2. Place under the coffee spouts:
- one cup, if you want one coffee (fig. 13);
- two cups, if you want two coffees (fig. 14);
3. Lower the spouts as near as possible to the
cup. This makes a creamier coffee (fig. 15).
4. Choose the strength by hitting the
and size by hitting the .
5. Press the icon corresponding to the number
of coffees required (one cup or two cups
) (fig. 9 and 16).
6. Preparation begins. A progress bar appears
on the display and gradually advances as the
procedure progresses (fig. 17).
Once the coffee has been made, the appliance is
ready to use again.
Information:
• While the machine is making coffee, delivery
can be interrupted at any moment by pressing
the lit cup icon.
• For a hotter coffee, before delivery rinse the
appliance through by pressing the icon
and confirming with the OK icon. Hot water
flows out of the coffee spouts and heats the
internal circuit of the machine so that the
coffee delivered will be hotter.
• For an even hotter coffee, heat the cups by
rinsing them with the hot water.
• If the coffee is delivered in drops, too fast
and not creamy enough or too cold, read the
tips in the “Troubleshooting” section on page
22.
making long coffee using coffee beans
Information: When this function is
activated, a long coffee similar to drip coffee is
obtained.
Important! Do not use caramelized or
candied coffee beans as they could stick to the
coffee mill and make it unusable.
1. Fill the container with coffee beans (fig. 12).
2. Adjust the height of the spout according to