DeLonghi Fully Automatic Coffee Center Machine ESAM6700 - Manual (Page 20)

19
Information!
If the brew group is
difficult to insert, you
must first adapt it to the
right dimension by
pressing it forcefully from
the bottom and top as shown in the figure.
7. Once inserted, make sure the
two red buttons have snapped
out.
8. Replace the drip tray and
grounds container.
9. Close the service door.
Cleaning the milk container
Clean the milk container each time you prepare
milk as described below:
1. Remove the milk
spout and intake
tube.
2. Remove the
selector by
pulling it
outwards.
3. Wash all the
c o m p o n e n t s
thoroughly with
hot water and
mild dish soap.
All components
can be washed
in a dishwasher,
placing them in
the top basket of
the dishwasher.
Make sure there
are no milk
residues left inside the holes and the groove
on the fine end of the selector.
4. Check that the intake tube and spout are not
clogged with milk residues.
5. Replace the selector, milk spout and intake
tube.
6. Replace the lid on the milk container, turning
it counterclockwise to hook it in place.
DESCALInG
Descale the machine when the message
“DESCALE!” flashes on the LCD display.
Important! Descaler contains acids which
may irritate the skin and eyes. It is vital to adhere
to the manufacturer’s safety warnings given on
the descaler pack and the warnings relating to
the procedure to follow in the event of contact
with the skin and eyes.
Information! Use De’Longhi recommended
descaler only. Under no circumstances should
you use sulphamic or acetic based descalers.
Their use invalidates the warranty. Failure to
descale the appliance as described above also
invalidates the warranty.
1. Turn the machine on.
2. Enter the programming menu by pressing
the p icon.
3. Press the or icon until “Descaling” is
displayed.
4. Select by pressing the oK icon.
“Descaling Confirm?” is displayed. Press OK
to activate the function.
5. The message “ Add descaler. Confirm?” is
displayed.
6. Before confirming, empty the water tank
(A13).
Pour the descaler diluted with water
(respecting the proportions indicated on the
descaler bottle) into the water tank.
Place an empty container with a minimum
capacity of 50 oz (1.5 L) under the hot water
spout.
Important! Danger di of burns Hot water
containing descaler flows out of the hot water
spout. Avoid contact with splashes of water.
7. Confirm by pressing the oK icon.
8. The message “Descaling Underway...” is
displayed. The descaling program starts and
the descaler liquid comes out of the water
spout.
The descale program automatically performs a
series of rinses and pauses to remove limescale
deposits from inside the machine.
After about 30 minutes, the message “Rinsing
FILL TANK!” is displayed.