Beurer FM 38 - Manual (Page 9)

9
5. Appliance description
Shiatsu foot massager
1 Platform with four massage heads that rotate in opposite
directions
2 Button
a Switch on massage function
b Switch on heating function
3 Power plug
6. Start-up
• Remove the packaging.
• Check the device, power supply and cables for damage.
• Connect the device to the mains power supply.
• Route the cable safely so that there is no risk of anyone tripping over it.
7. Operation
When seated comfortably place your feet on the two platforms. The rubber feet on the base of the unit
prevent it from sliding.
Switch on the massage device with the ON/OFF button. Press the heat button to switch on the heating
function. Press the ON/OFF button again in order to switch off the appliance.
The massage must be pleasant and relaxing at all times. Stop the massage or change your position or the
contact pressure if you find it is painful or unpleasant.
• Do not force any part of your body, in particular your fingers, between the rotating massage heads and
their mountings in the device.
Note
• Do not use the massage device for longer than 15 minutes. Otherwise, using the device for longer
can over-stimulate the muscles and cause tension instead of relaxation.
Massage of a specific point on the sole of the foot may influence the corresponding organ of the body.
However, we recommend studying relevant literature and asking your doctor before using point reflex
zone massage to achieve the desired effect.
8. care and storage
cLeANING
WARNING
• Disconnect the device before cleaning it.
• Clean the device with a very slightly damp cloth only. Fluid must never be allowed to enter into the
device or accessories.
Storage
If you do not use the device for longer periods, we recommend storing it in the original packaging in a dry
place without weighting it down.
2 a
2 b
3
1
1