Beurer MC 3000 - Manual (Page 21)

21
8. What if there are problems?
Problem Cause Solution
Massage heads are
moving slowly.
The load on the massage heads is too
great.
Reduce the contact pressure from >
your body.
Massage heads are
moving in the upper or
lower area only.
The massage was only activated for the
limited area in question.
Press the FULL BACK, UPPER >
BACK or LOWER BACK button to
change or extend the area.
Grinding noises during
operation.
These sounds are normal and are caused
by the operation of the motor or from the
massage heads that are rubbing against
the cushion.
No action is necessary.
The massage cannot be
started.
The mains plug is not connected to the
socket.
Plug the mains plug into the socket. >
The 3D Shiatsu massage was not switched
on at the control element.
Switch on the massage chair using >
the on / off button .
The massage function
stops when the chair is in
operation.
The maximum operation period was
reached.
Switch off the massage chair and >
allow to cool down for 30 minutes
before switching on again.
9. Technical Data
Product description Massage chair MC3000
Mains voltage/frequency 100-240 V ~ 50-60 Hz
Energy consumption 42 W
Dimensions (in flat position) Length 140.5 cm, width 76.0 cm, height 99.0 cm
Weight Net: 30 kg, with packaging 36.5 kg
Maximum load capacity 135 kg
10. Disposal
Observe the local regulations for material disposal.
Dispose of the unit in accordance with EC Directive
2002/96/EC – WEEE (Waste Electrical and Electronic
Equipment).
If you have any questions, please contact
the local authorities responsible for waste
disposal.
11. Warranty and service
In the event of a warranty claim or service case,
please contact Customer Services in your respective
country.
You can find the address in the enclosed address list.