Beurer MG 250 - Manual (Page 13)

13
6. Start-up
CaUTIOn
• IMPOrTanT: Before using the device for the first time, ensure you have released all transport
locks on the massage mechanism. To do this, remove the screws using the tool provided on
the rear of the seat cover. If the transport lock screws are not removed first and the Shiatsu
seat cover is used immediately, the device will become irreparably damaged and unusable.
The warranty will not apply in this instance.
• Reuse the transport lock screws when transporting the device in the future. Transporting the device
without using the transport locks could cause irreparable damage to the device.
• Position the seat cover upright on a suitable seating arrangement with seating surface and backrest
(chair, sofa, or similar). Ensure that the seat cover is supported over its entire area and has a suf-
ficiently high backrest.
• Use the flexible fastening straps and Velcro strips to secure the Shiatsu seat cover.
• Connect the device to the mains by plugging the plug into the socket.
7. Operation
Gently press your back against the massage device to start with. Then make sure that you are in a comfort-
able position before gradually shifting your weight onto the massage device.The massage must be pleasant
and relaxing at all times. Stop the massage or change your position or the contact pressure if you find it is
painful or unpleasant.
• Do not force or jam any part of your body, in particular your fingers, between the rotating massage elements
or their holders in the unit.
• Sit comfortably and upright on the seat cover. Ensure you sit centered and such that the massage heads
can move to the left and right of your spinal column.
• Switch on the massager with the button.
The LEDs signal the massage functions which are currently selected.
You can specify the settings as follows:
1. Demo run
Press the demo button to begin a quick 5-minute run-through of the functions contained in the device.
The manual controller indicates which function is being displayed by flashing the respective LED. The
device switches off automatically once the demo run has finished.
2. Shiatsu neck massage
Press the NECK button to start the neck massage. Press it again to change the massage direction. Press
the button once more to end the neck massage.
3. Shiatsu back massage
Press the SHIATSU button. Select the desired massage region with FULL BACK, UPPER BACK and LOWER
BACK.
Spot massage, i.e. Shiatsu massage without vertical movement, can be selected by pressing one of the
two SPOT buttons. The position of the localised massage can be changed by pressing and holding one
of the two SPOT buttons until the desired position is reached.
Massage intensity
When using the Shiatsu Massage, two different massage speeds are available, which can be selected us-
ing the SPEED button. If you have the rolling massage activated, first press the SHIATSU button in order
to change to Shiatsu Massage and then set the desired massage speed.
4. rolling massage
Press the ROLLING button. Select the desired massage region with FULL BACK, UPPER BACK and LOWER
BACK.
When the massage type (Shiatsu or rolling massage) is changed, the preselected region (full, upper, lower
back) is retained. Note that the massage region must be selected again when switching from localised
Shiatsu massage to rolling massage.