Datalogic Scanning 6000 - Manual (Page 15)

Programming Guide
11
IBM 4682/92 Port E Interface Selection
Scan this label to enable the IBM 468x/9x Port E interface.
IBM 4682/92 Port E Settings
Data Format: Send As Code 39 — converts bar code data (UPC/EAN,
add-ons, Code 93, Codabar, MSI/Plessey and Code 128) into Code 39
format before sending the data to the host.
These settings are for IBM 4682/92 Port E interface ONLY.
Limit Command Set — is an option that causes the scanner to ignore
'enable scanner' and 'disable scanner' commands sent from the host.
Transmit Unsolicited Status
1 — when enabled, this option causes the scanner
to transmit a status message to the host upon receipt of an "SNRM".
SET ----------------------------------------------
S
END AS
C
ODE
39 ----------------
D
ON
'
T
S
END AS
C
ODE
39 --------
E
NABLE
L
IMIT
C
OMMAND
S
ET
-----
D
ISABLE
L
IMIT
C
OMMAND
S
ET
-----
T
RANSMIT
U
NSOLICITED
S
TATUS
---
D
ON
'
T
T
RANSMIT
U
NSOLICITED
S
TATUS
---
END ----------------------------------------------
1 For this IBM interface, the setting for Unsolicited Status is normally Disabled.
D
ATA
F
ORMAT