Datalogic Scanning 6000 - Manual (Page 95)

DEFAULT
FEATURE
IBM 468x/9x
Port 5B
IBM 468x/9x
Port 9x OCIA (DLS) OCIA (SNI)
Record Your
Default Set
General Features
Audible Signal Enable Enable Enable Enable
Power-Up Beep Enable Enable Enable Disable
Beeper Volume High High High Low
Beep Duration 100ms 100ms 100ms 100ms
When to Beep
Beep/LED After
Decode
Beep/LED After
Decode
Beep/LED After
Decode
Beep/LED After
Decode
Low Power Mode Disable Disable Disable Disable
Debug Mode Disable Disable Disable Disable
AutoSense Stand Mode Disable Disable Disable Disable
IBM I/F s Settings
IBM Port 5B I/F Enable N/A N/A N/A
IBM Port 9X I/F N/A Enable N/A N/A
IBM Port E I/F N/A N/A N/A N/A
Send as Code 39 Disable Disable N/A N/A
Limit Command Set Disable Disable N/A N/A
Unsolicited Status Transmit Don't Transmit N/A N/A
OCIA I/F Settings
DLS OCIA I/F N/A N/A Enable N/A
NCR OCIA 8-Bit I/F N/A N/A N/A N/A
NCR OCIA 9-Bit I/F N/A N/A N/A N/A
SNI OCIA I/F N/A N/A Disable Enable
Beep if Not on File N/A N/A Disable Disable
Host Commands N/A N/A Enable Enable
Intercharacter Delay N/A N/A Disable Disable
Wand Em. I/F Settings
Wand Emulation I/F N/A N/A N/A N/A
Polarity N/A N/A N/A N/A
Signal Speed N/A N/A N/A N/A
Data Format N/A N/A N/A N/A
Idle State N/A N/A N/A N/A
Transmit Pre-Noise N/A N/A N/A N/A
Transmit C128 Function
Characters
Disable Disable Disable Disable