Beurer LB 50 - Manual (Page 21)

19
7
IN THE EVENT OF PROBLEMS
Problem Cause Remedy
No steam
exiting
Appliance not connected to power Insert the plug [14] into the
mains and switch on the
appliance.
Water tank [8] empty. Replenish water.
Water tank [8] not fitted correctly. Fit tank properly.
Appliance
leaking Water tank [8] leaking. Replace tank.
Water tank [8] not shut properly. Fasten the catch properly.
Steam tower [3] not installed or not
installed correctly. Install steam tower [3]
properly.
Delay in steam
output Very cold water in tank. Use warmer water.
Appliance heavily scaled. Descale the appliance.
Red indicator
[A] illuminated Water tank [8] empty. Replenish water.
Valve on tank catch [9] is covered
with dirt. Clean the valve.
Appliance heavily scaled. Descale the appliance.
Water tank [8] not shut properly. Close the catch properly.
Water tank [8] not fitted correctly. Fit tank properly.
If the problem persists, please contact customer service.
8 T
ECHNICAL DETAILS
Rated output 380 W
Nominal voltage 230 V / 50 Hz
Water tank volume approx. 5 litres
Evaporation rate
• Level 1: 150 ml/h
• Level II: 400 ml/h
Overheating protection Through thermostat
Safeguard against running dry If there is not enough water in the heater unit, the
appliance switches off automatically. The appliance has
a sensor which detects the water level.
Switching 2-stage
Weight 2.8 kg
Dimensions (W / H / D) 235 / 315 / 280 mm
Connection Fixed cable, approx. 2 m in length