BrightSign HD2000 Network Manager Guide User Manual
Page 25
Managing Your BrightSign Network 21
•
•
•
•
•
•
• update_newer.rok: Use this file name if you want to apply the update only if the version is
newer than the version currently on the BrightSign. The update file is not deleted.
• update_different.rok: Use this file name if you want to apply the update only if the version
does not match the version currently on the BrightSign. The file is not deleted.
4
Run the update:
a
Insert the CF/SD card into the BrightSign.
b
Apply power and wait for the unit to boot. If a display is connected it will be blank, but the
LEDs on the front panel light as the unit boots.
c
Wait for the red upgrade LED to light up. During the upgrade, the connector activity LEDs
turn on and off to indicate that the upgrade is in progress.
• If you named the file update.rok, the file deletes when the update finishes and the unit
reboots.
NOTE:
If the card was formatted with NTFS or HFS+, then the update.rok file does not delete and
the unit does not reboot after the update. Instead, the Video Mode LEDs flash.
• If you named the file update_save.rok, the Video Mode LEDs flash when the update
finishes. The upgrade file does not delete and the unit does not reboot.