Broadata Communications LBC-H/V-T-WP - Manual (Page 11)

LBC-H/V-T-WP User’s Manual
Link Bridge
TM HDMI/VGA Wall Plate Transmitter System
Broadata Technical Support, (800) 214-0222 12
3.6 Serial Data Interface
To transmit RS-232 data, connect data source to the terminal
block shown in Figure 3-5.
RS-232 Data
The LBC-H/V-T-WP transmits one channel of RS-232 data.
Follow the procedures for installing data terminal devices.
1. Label and connect one serial data cable to the user’s RS-232
device.
2. Connect the other end of this cable to the rear panel data
terminal block connector on the LBC-H/V-T-WP (see
Figure 3-5) per the pin out diagram in Figure 3-6.
Figure 3-5
User’s RS-232 Data Source