BSS Audio sw9088iis Install Guide - Manual (Page 4)

130
Soundweb
TM
Audio & Control cable wiring details
All audio and control connections to the 9088 are via Klippon pluggable terminal block
connectors (also known as BL, Phoenix or Combicon). 6-way female Klippon connectors
are supplied for making these connections.
Audio Input and Output wiring convention Audio Input and Output wiring convention Audio Input and Output wiring convention Audio Input and Output wiring convention Audio Input and Output wiring convention
Soundweb products provide cable shielding ‘back from the destination’ to eliminate
ground loop problems. This means that the shield (S) connection on an input is
grounded, whereas the shield connection on an output is floating (although connected
via an internal network to ground for EMC compliance).
Balanced wiring - The convention for balanced wiring (2-core plus shield) is:
Balanced connection 9088 connection
Pin 3: Cold '-'
Pin 2 : Hot '+'
Pin 1 : Shield
Unbalanced wiring - The convention for unbalanced wiring to the inputs (1-core plus
shield) is:
Unbalanced connection 9088 connection
Pin 1: Shield
Pin 2 : Hot '+'
Pin 3 : Link to Pin 1
(Optional for 9088 inputs)
RX - 5
GND - 4
TX - 3
RTS - 1
CTS - 2
Front panel details
RS232 RS232 RS232 RS232 RS232
Used to connect one of the 9088 units in the network to a controller PC (cable supplied
with unit), which can then communicate with any device on the network. The pin out is: