BSS Audio BLU-GPX Owner's Manual - Manual (Page 5)

5
Front Panel
General Purpose Indicator LEDs
These 48 software-programmable LEDs
can be assigned to a control port or can
be driven by the Soundweb London Logic
system. Each LED is a multi-color indicator
capable of red, green, or yellow illumination
and can be independently configured within
London Architect.
Power Supply LED
When lit, this LED provides indication that the BLU-GPX is being powered
through the SECONDARY POWER input connection on the back panel.
Network Link
This LED indicates the presence of Cat 5 Ethernet cables. If no cables are
connected, the LED is unlit; the LED lights if a control cable is fitted.
Data Activity
This LED will flash to indicate that the device is communicating with another control
device, either on the network or via the serial or control ports.
LCD Display
Top line Indicates device name and run state. Bottom
line indicates Time, IP Address, Subnet Mask, Model
number with firmware version. Also, the device’s MAC
Address can be viewed by powering the device on
whilst pressing and holding the LOCATE switch. This
display can be configured to display custom text using
the Logic Display object in London Architect.
Locate
Pressing the LOCATE switch on the front of the unit will illuminate the LOCATE switch
on the rear and identify the device within London Architect. Similarly the switch will
illuminate if the device is selected from within London Architect or from the LOCATE
switch on the rear.
Contrast (Hold)
Pressing and holding the LOCATE switch will cycle the LCD through its contrast range.