BSS Audio DPR-402 Owner's Manual - Manual (Page 10)

1 0
The compressor section allows you full control over all the normal parameters,
and offers 'auto' time constants for general purpose use. The control and
subtract side chain insertion points allow numerous applications for the
patching of the units own, or external, filters to provide dynamic tonal
modification. The calibrated peak limiter allows absolute control without
having to compromise the dynamics setting of the compressor, potentially
resulting in less dynamic distortion for an equivalent amount of compression.
The DPR-402s user friendliness is well demonstrated by the sophisticated yet
uncluttered LED metering and monitoring facilities. The full compressor
operating range is displayed on a two part meter, indicating both signals
below threshold and actual gain reduction. The arrangement of these two
meters, together with the full scale 'bright-up' feature, ensures that operation
will always be within the permitted VCA window, making it virtually
impossible to exceed the systems parameters unintentionally.
The output is continuously monitored on the output level meter, which also
incorporates the full scale 'bright-up' facility. The bypass switch, in
conjunction with the meter input switch, provides a powerful aid for initially
setting up the unit. The straight signal and the processed signal may be
monitored on the output level meter without affecting the output from the
unit, thus enabling system gains to be equalised while in the bypass mode.
Like all BSS Audio equipment, the DPR-402 has been designed to withstand
harsh treatment on the road, yet has a specification to satisfy the most
stringent studio and broadcast work.
5.0 Earthing Requirements
WARNING! THIS APPLIANCE MUST BE EARTHED.
IMPORTANT: The wires in the mains lead are colour coded in accordance
with the following code.
Green and Yellow......Earth
Blue......Neutral
Brown......Live
As the colours of the wires in the mains lead may not correspond with
the markings identifying the terminals in your plug, proceed as
follows.
! The wire which is coloured Green and Yellow or Green must be connected
to the terminal which is marked with the letter ‘E’ or by the Earth signal
or which is coloured Green and Yellow or Green.
" The wire which is coloured Blue must be connected to the terminal
labelled ‘N’ or coloured Black or Blue.
# The wire which is coloured Brown must be connected to the terminal
labelled ‘L’ or coloured Red or Brown.
Earthing Requirements