BSS Audio FCS-960 Owner's Manual - Manual (Page 12)

1 2
FCS-930/960
Rear Panel
5.2 Rear Panel
8 Mains power fuse is 20mm long and rated at T250mA for 120V voltage setting and
T200mA for the 240V voltage setting. For continued protection, please always replace
this fuse with the correct value.
9 Mains power switch.
10 Mains voltage selector switch allows operation from 90V-130V or 190V-250V.
11 Electronically balanced and floating output. Maximum output is +20dBu into 600
Ω
.
Transformer balancing is available as an option.
The pin connections are:
Pin 1 Ground/chassis.
Pin 2 Hot (+).
Pin 3 Cold (-).
12 Electronically balanced input. Maximum input is +20dBu into 10k
Ω
. Transformer
balancing is available as an option.
The pin connections are:
Pin 1 Open circuit/no connection.
Pin 2 Hot (+).
Pin 3 Cold (-).
Please take special note of the ground break on Pin 1. As with all BSS products, the
convention is ‘screen goes forward with the signal’, giving a useful ground loop break
point at the input connector. The audio lead connected to the input must therefore
have it’s screen grounded at the signal source end.
When using a fully balanced system, either Pin 2 or Pin 3 may be the HOT terminal.