BUG-O Systems MM-1 - Manual (Page 14)

14
PROGRAMMING MODES
The machine runs in either the SHAPE PROGRAM, for custom programmed shapes, or the PIPE
PROGRAM, for pipe intersections.
To switch functions:
1. Press “C” on the pendant keypad
2. Release the key immediately
3. Press “F” immediately (within half a second)
The machine should change to the other program:
EXAMPLE: If the machine is in the PIPE PROGRAM, the Message “PIPE PROG” should be
displayed on the pendant display. If the machine was in the SHAPE PROGRAM, the message
“SHAPE PROG” should be displayed in the pendant display.
SAVING PROGRAMS
The machine has 10 storage areas numbered cut 0 to 9 in memory, either PIPE PROGRAMS or SHAPE
PROGRAMS can be saved in memory. To switch to a different cut number, Push “C” on the pendant
keypad and enter the desired number. Program data is retained until reprogrammed. At any time, one of
these numbers are selected, it will stay selected even when power is shut off and turned back on, it will
not change until the program number is changed by the operator.
PROGRAMMING, DATA ENTRY
When entering data with the pendant keypad, multiply inches, degrees, or seconds by 100 and enter the
number without a decimal point. For metric dimensions, multiply mm X 10 or cm X 100.
Example: 350 for 3.5 inches,
800 for 80 mm, on metric machines
1500 for 15 degrees
Press the return button after the number is entered.