BUG-O Systems MM-1 - Manual (Page 17)

17
PROGRAMMING, CUTTING HOLES (Type 5)
To program TYPE 5 Holes utilizing the “Pipe Program”. The machine is programmed to cut holes in pipes
for branch joints, either square (t-joints) or angled (laterals). The joint must be on Centerline.
The Display will ask for:
1. The small diameter, and then the large diameter. Enter the diameter of the branch pipe for
small diameter, as shown in the diagram below, and the diameter of the pipe being cut for the
large diameter.
2. Next the display will ask for the angle. Enter the angle, in degrees X 100 (e.g. for 60 degrees,
enter 6000). For square cuts you must enter 9000 (for 90 degrees).
Large Diameter
Angle
Small Diameter