Campomatic UC990B Tornado - Manual (Page 4)

3. Use & Function
IMPORTANT: Always remove the power plug
from the electrical outlet before assembling or
removing accessories.
1. Insert the handle
into the top of the
vacuum cleaner.
(Fig.3/1).
4. How to Operate
On/Off Pedal
Plug the cord into an electrical outlet. Turn
the vacuum cleaner on by pressing the on/
off switch located on the lower side of the
cleaner (Fig.4/1). The cleaner can be turned
off by pressing the on/off switch again.
Telescopic Handle
The telescopic handle is adjustable. Push the
handle adjuster button to slide the handle up
and down. (Fig.4/1).
The telescopic handle can also be used as an
extension tube when using the accessories
(see section 5).
4 5
6. Dirt Container & Filter:
Removal & Replacement
IMPORTANT: Always unplug the vacuum
cleaner from the electrical outlet before
emptying the dirt container.
IMPORTANT: Do NOT use the vacuum
without the HEPA filter in place.
1. To remove the dirt container, press the dirt
container release button and lift away from
the vacuum cleaner (Fig 6/1).
Auto Cord Rewind
Unplug the vacuum cleaner from the electrical
outlet. Press the auto cord rewind pedal and
guide the power cord with one hand. Rewind
1-1 1 /
2
metres of cord at a time. This will
prevent the cord from whipping which could
cause damage or injury. (Fig.4/2).
Fig.4/2
Adjustment for Floor Types
The vacuum cleaner has a brushbar height
adjuster that raises and lowers the brushbar
to suit different carpet types. With the cleaner
NOT connected to the electrical outlet, set the
adjustment to the lowest setting for maximum
cleaning. If the cleaner is difficult to move, push
the knob to the next highest setting until the
vacuum cleaner is comfortable to push. The
brushbar must reach the carpet for effective
cleaning. (Fig.4/3). To use the telescopic handle, release the
handle by pushing the handle release button
and connect the hose to the top of the
telescopic handle (Fig.5/3).
Attach the desired accessory to the end of
the telescope handle (Fig.5/4).
CAUTION: The brushbar continues to rotate
while the hose is removed and at all times
when the vacuum cleaner is on. Keep hair,
loose clothing, fingers and all parts of the body
away from the brush area while the vacuum
cleaner is on. The vacuum cleaner must be in
the upright position to lift the rotating brushbar
off the carpet when cleaning with extendible
hose. When using tools/accessories, the
brushbar height adjuster should be turned to
its highest position.
5. Accessories
Crevice Tool
Use the crevice tool for crevices, corners,
skirting boards and between cushions.
Dusting brush
Use the dusting brush on soft furnishings.
Attaching the Accessories
The crevice tool and dusting brush can be
used with or without the telescopic handle.
To attach the accessory to the hose, remove
the hose from the machine (Fig.5/1) and push
the accessory onto the end (Fig.5/2).
3. Empty all the dirt
from the container
(Fig.6/3).
4. Remove the HEPA
filter by twisting
anti-clockwise and
pulling out (Fig.6/4).
NOTE: The white
material in the HEPA
filter will discolour over
time - This is NORMAL
and will NOT affect the
performance of the filter.
5. Firmly tap clean the HEPA filter until no
more dust is observed falling out (Fig.6/5).
Fig.3/1
Fig.4/1
Power
On/off
Fig.4/3
Fig.5/1
Fig.5/2
Fig.5/3
Fig.5/4
Fig.6/1
2. Release the
bottom of the
dirt container
by pushing the
button located
at the back of the
dirt container.
(Fig.6/2).
Fig.6/2
Fig.6/3
Fig.6/4