Cetacea Sound PAS I Presentation Audio System Quick Start Guide - Manual

IMPORTANT SET-UP INSTRUCTIONS
Please read all of the following quick set-up instructions and the complete Owner’s
Manual before attempting to use the PAS I.
Speakers Only
1) The input jack is located on the wire at the base of the volume control
knob. Push it into the headphone jack on your computer or portable CD
player to play the PAS I for the first time.
2) Do not adjust the volume on the computer, CD player, or PAS I above
75%, computers and CD players exhibit distortion at high volume levels.
3) If your computer or CD player has a BASS BOOST, or special effects
like Spatializer, SRS, or controls that say JAZZ, ROCK, BLUES, etc., turn
them off for now.
4) The PAS I speakers require power from their power adapter (PASI-SW).
Plug the power adapter into a suitable source of either 110v power and
the opposite small end into the base of the volume control. (It will only fit
in one location.)
5) Place PAS I speakers on any flat surface and turn on the music. Be sure
to use a high quality recording to fully appreciate the awesome sound of
the speakers. Once you are satisfied with the sound, add the subwoofer
for extended bass response. (Refer to owners manual.)
READ THESE INSTRUCTIONS CLOSELY 12/09 200904-019
PAS I Presentation
Audio System
Quick Start Guide
Model #: PASI-AVD-CC & PASI-PORT