CHIAYO UDR-1000 - Manual (Page 6)

Press MENU until
this page appears.
Press SET button for 2 seconds to enter the SET mode and the following display will
appear and the cursor will flash.
Press SET again each time will move the cursor one position. The first two digits on
the top left is the Group and the second two digits on the top right is the Channel.
There are all together 25 Groups and 40 Channels ( 25*40=1000 ) preset frequencies
to be chosen. Use the ▲ or ▼ button to select the digit. Press SET again to save the
change and move the cursor one position forward. Once either the Group or the
Channel has been altered, the frequency will be changed automatically. After
finishing all the changes, press SET button for about 3 seconds to save the changes.
A←801.100MHz→B
RF-----------AF------------
CF : 01 - 01
800.000 MHz
CF : 01 - 01
800.000 MHz
2. To change Frequency
USER MODE
PRESET MODE ←
USER MODE
PRESET MODE ←
4. To go to User Mode
Press MENU until
this page appears.
Press SET button for 2 seconds to enter the SET mode. Use the ▲ or ▼ button to
select either USER or PRESET mode. "←" indicates selected. After making the
change, press SET button for about 3 seconds to save the change.
SQUELCH LEVEL
-95 dBm ( 2 )
SQUELCH LEVEL
-95 dBm ( 2 )
3. To change Squelch level
Press MENU until
this page appears.
Press SET button for 2 seconds to enter the SET mode and the cursor will flash on
only one spot. Use the ▲ or ▼ button to select one of the 8 preset levels. After
making the change, press SET button for about 3 seconds to save the changes.
1. Making changes to User Name:
Press the ▲ or ▼ button to
Press SET for about 3 seconds to enter the SET mode and the cursor will start flashing.
Press SET separately to move the cursor to the desired position where change is needed.
Press the ▲ or ▼ button to select the character or number and press SET to make the
change and move the cursor one step forward. After finishing all the changes, press SET
for about 3 seconds to save the changes.
Making changes to various settings in UH-2000 / UB-2000
USER NAM
C F : 0 1 - 0 1
2. Making changes to User Name:
Press the ▲ or ▼ button to
Press SET for about 3 seconds to enter the SET mode and the cursor will start flashing.
Per press of SET can move the cursor one step to the desired position to change the
frequency. The first two digits on the left are GROUP ( GP ) and the two digits on the right
are CHANNEL ( CH ). There are altogether 25 preset Groups and 40 preset Channels
available for selection. Press the ▲or ▼ button to select the number. As the GP or CH
number is changed, the preset frequency will appear in the second line accordingly. After
changes fninshed, press SET button for about 3 seconds will save the changes.
CF:01-01
650.000
3. Making changes to Sensitivity Level:
Press the ▲ or ▼ button to
Press UP or DOWN button to increase or decrease the Sensitivity Level of the transmitter.
The MAX level is 4 and the MIN level is 1.
When a desired sensitivity level has been selected for your application, it will be
automatically saved and stored in the Memory.
Remark : When selecting Sensitivity level, please bear in mind that Level 1 is for
close proximity singing purposes whereas Level 4 is for use of transmitter on
tripod mount for speech purposes. When Level 4 setting is used for close
proximity singing, high SPL input will result in undesirable distortion in the
output.
SENS SET
LEVEL[1]
5 10