Cloud Electronics MPA60 - Manual (Page 4)

MPA Series User Manual v1.2 4
Safety Information
Safety Notes regarding Installation
•
Do not expose the unit to water or moisture.
•
Do not expose the unit to naked flames.
•
Do not block or restrict any air vent.
•
Do not operate the unit in ambient temperatures above
35
O C.
•
Do not touch any part or terminal carrying the
hazardous live symbol ( ) while power is supplied to
the unit.
•
Do not perform any internal adjustments unless you
are qualified to do so and fully understand the hazards
associated with mains-operated equipment.
•
The unit has no user-serviceable parts. Refer servicing
to qualified service personnel.
•
If the moulded plug is cut off the mains lead for any
reason, the discarded plug is a potential hazard and
should be disposed of in a responsible manner.
For more detailed information refer to the rear of the manual.
Safety Notes
Conformities
This product conforms to the following European EMC
Standards:
BS EN 55103-1:1997
BS EN 55103-2:1997
This product has been tested for use in commercial and
light industrial environments. If the unit is used in controlled
EMC environments, the urban outdoors, heavy industrial
environments or close to railways, transmitters, overhead
power lines, etc., the performance of the unit may be
degraded.
The product conforms to the following European electrical
safety standard:
BS EN 60065:2002
The MPA Series was developed and manufactured with high
quality materials and components, which can be recycled
and/or reused.
The WEEE symbol indicates that
electrical and electronic equipment
must be disposed of separately from
normal waste at the end of its
operational lifetime.
Please dispose of this product by taking it to your local
collection point or recycling centre.
Safety Considerations and Information
The unit must be earthed. Ensure that the mains power
supply provides an effective earth connection using a three-
wire termination.
When the mains switch is in the off ‘O’ position the live
and neutral conductors of the mains transformer are
disconnected.
Caution - High Voltages
Do not touch any part or terminal carrying the hazardous
live symbol ( ) while power is supplied to the unit.
Terminals to which the hazardous live symbol refers require
installation by a qualified person.
Caution - Mains Fuse
Replace the mains fuse only with the same type and rating as
marked on the rear panel.
The fuse body size is 20mm x 5mm.
Caution - Servicing
The unit contains no user serviceable parts. Refer servicing
to qualified service personnel. Do not perform servicing
unless you are qualified to do so.
Disconnect the power cable from the unit before removing
the top panel and do not make any internal adjustments with
the unit switched on.
Only reassemble the unit using bolts/screws identical to the
original parts.