Code CR2 - Manual (Page 65)

C001537_18_CR2_User_Manual 59
Save Settings
7.1 - Reset Reader to Factory Defaults
Scan the following codes to reset reader:
Reset to USB Factory Reset to PS/2 Factory Reset to RS-232 Factory
Default Settings Default Settings Default Settings
Reset to RF One Way Bootloader Mode
Factory Default Settings
Clear All CodeXML Rules
Prefix & Suffix Clear All Stored Data Save Settings
7.2 - General Safety Information
Repairs and Adjustments - Only those individuals authorized by Code should attempt to make repairs or adjustments to
CR2 equipment. If the reader casing is opened the warranty is voided.
Power Supply - Use only the power supply provided for use with each specific unit when operating Code equipment.
Accessories - Only those accessories approved by Code (see page 3) should be utilized with Code equipment. Non-
compliance with any of the above may result in:
• Injury to individuals handling the equipment;
• Damage to the equipment; and
• Voiding of the maintenance contract.
Lasers - The CR2 utilizes a laser FOR TARGETING PURPOSES ONLY. If the laser is activated, do not stare into the
beam. See pg i for further information regarding laser warnings.
Lithium Ion Battery - Warning: Charge the battery with Code cables ONLY. Do not open battery, dispose of in fire, or
short circuit - it may ignite, explode, leak, or get hot causing personal injury.
Bootloader mode is
utilized to download new
version of bootloader
firmware.