Comtech EF Data CDM-600/600L - Manual (Page 274)

CDM-600/600L Open Network Satellite Modem Revision 3
Appendix J MN/CDM600L.IOM
J–4
CONFIG: TX
Æ POWER Æ MODE Æ AUPC
CONFIG: TX
Æ POWER Æ MODE Æ AUPC-LOW
For either of the AUPC modes selected, the lower line of the menu changes as follows:
Select either TARGET-EbNo/RANGE or ALARM ACTION using the [
←][→] arrow keys
then press [ENT].
CONFIG: TX
Æ POWER Æ MODE Æ AUPC Æ TARGET-EbNo/RANGE
CONFIG: TX Æ POWER Æ MODE Æ AUPC-LOW Æ TARGET-EbNo/RANGE
Edit the target Eb/No of the remote modem. The default value is 3.0 dB, and upper limit is 14.9 dB.
Then, edit the maximum permitted increase in power level when in AUPC mode. The default value
is 1dB, and upper limit is 14.9 dB. Press [ENT] when done.
CONFIG: TX
Æ POWER Æ MODE Æ AUPC/AUPC-LOW Æ ALARM/ACTION
Use the [
←][→] arrow keys to select the MAX TX PWR ACTION parameter (on the top line of
the display), then use the [
↑][↓] arrow keys to select NONE or Tx ALARM to determine the action
that will occur if the AUPC causes the maximum output power level to be reached.
Next, use the [
←][→] arrow keys to select the REM DEMOD UNLOCK ACT parameter (on the
bottom line of the display), then use the [
↑][↓] arrow keys to select NOM-PWR or MAX-PWR to
determine the action that will occur if the remote demod is unlocked:
• When NOM-PWR (Nominal Power) is selected, the output level will revert to the nominal
power level set under MANUAL
• When MAX-PWR (Maximum Power) is selected, the ouput level will change to the
maximum power level permitted under MANUAL.
Press [ENT] when done.
TX POWER MODE=AUPC (MAN,AUPC (LOW))
TARGET-EbNo/RANGE ALARM/ACTION
MINIMUM EbNo OF REMOTE MODEM = 5.0dB
MAXIMUM PERMITTED POWER INCREASE =14.9dB
MAX TX PWR ACTION = NONE (NONE, TX-ALM)
REM DEMOD UNLOCK ACT = NOM-PWR(NOM, MAX)