Comtech EF Data SFC1800A - Manual (Page 58)

User Interfaces SFC1800A Synthesized Frequency Upconverter
4-34 TM111 - Rev. 1.0
4.6.2.4 Logging On
1.
The user must be logged on to have access to SNMP Features. To log on the SNMP
configuration, press ‘50’ followed by <ENTER> to open the Logon Dialog Box.
+ - - - - - - - - - - - - - - - - - - | Logon | - - - - - - - - - - - - - - - - - - - - - -+
| |
| 1.User ID : |
| 2.Password : |
| 3.OK 4.CANCEL |
| |
+ - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - +
2.
In the User ID Text Box, enter “Oper-md5” (case sensitive).
3.
In the Password Text Box, enter “Oper” (case sensitive).
4.
Select OK
4.6.2.5 Changing the Logon Password
To change the password, logged on so that the “SNMP/Security” selection appears. Press ‘54’
followed by <ENTER> to open the Change Logon Password dialog.
+ - - - - - - - - - - - - - | Change Password | - - - - - - - - - - - - - - - - - -+
| |
| 1.Old Password: |
| 2.New Password: |
| 3.Re-enter New Password: |
| 4.OK 5.CANCEL |
| |
+ - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - +
1.
In the Old Password Text Box, enter “Oper” (case sensitive).
2.
In the New Password Text Box, enter the new password (case sensitive, only *’s appear
for security).
3.
Re-enter the new password to verify the desired setting.
4.
Select OK
4.6.2.6 Logging Off
1.
To log off the SNMP Configuration, press ‘51’ followed by <ENTER>. The following
confirmation message will be displayed to avoid inadvertent exits:
You will be logged off. Are you sure? (Y/N):