Comtech EF Data CMR-5970 Manual - Manual (Page 16)

Digicast Media Router S2 Receiver CMR-5970 (MR-S2) & CMR-5990 (MR-S2-ASI) Revision A
Introduction MN/MRS2ASIDC.IOM
The MR-S2 receives Multiprotocol Encapsulated (MPE) data as specified in ETSI EN
301 192 over MPEG-2 packets or raw Transports Streams (TS) carrying audio, video or
data over an L-Band or ASI input.
The MR-S2 supports:
•
DVB-S (2 to 45 Msps)
o FEC Rates: 1/2, 2/3, 3/4, 5/6 and 7/8
•
DVB-S2 QPSK (6 to 32 Msps)
o FEC Rates: 1/2, 3/5, 2/3, 3/4, 4/5, 5/6, 8/9 and 9/10
•
DVB-S2 8PSK (6 to 32 Msps)
o FEC Rates: 3/5, 2/3, 3/4, 5/6, 8/9 and 9/10
1.2 Standard Features
Based on an embedded architecture, utilizing a FreeScale MPC859 CPU and
eCOS Operating System, the MR-S2 provides the following features:
• High Reliability
• DVB-S and DVB-S2 L-Band Input
• ASI Input at rates as high as 213 Mbps (option with MR-S2-ASI only)
• Ethernet Output rates as high as 85 Mbps (1,500 byte packets)
• ASI Output rates as high as 213 Mbps (option with MR-S2-ASI only)
• Support for Multicast and Unicast IP datagrams
• Supports the decapsulation of MPE
• MPE Section Packing and Non-Section Packing on a PID-by-PID basis
• Supports encapsulation of transport streams over IP
• Support for all valid PIDs in 8192 range
• 64 PIDs on each input (ASI or L-Band)
• MPEG-2 188/204-byte operation
• Support for 802.1Q VLAN Tags
• IGMP for Multicast Route Announcements
• Configurable Telnet and HTTP ports for security
• Color LEDs for status monitoring and rapid fault isolation
• Management (monitor, control and configuration):
o Web Interface
o TFTP for field software/firmware upgrade
o Terminal Interface
o Telnet
o SNMP V2 (Private and MIB II) Support (Future release)
1–2