Comtech EF Data UB-54 - Manual (Page 17)

UB-54 Breakout Panel Installation
Rev. 1 2–3
UB-54
SDM-300 W/INTEGRATED
8 CHANNEL MULTIPLEXER
TRIB 1 DATA TR IB 2 D ATA TRIB 3 DATA TRIB 4 DATA TR IB 5 D ATA TRIB 6 DATA TRIB 7 DATA TRIB 8 DATA AUX
J9 J8 J7 J4 J1 J2 J3 J5 J6
MUX / DEMUX
BREA KOU T
UB-54
SDM-300
SATELLITE MOD EM
TRANSMIT
RECEIVE
T RANSMIT
RECEIVE
CO MMON
STO RED
POWER ON
TRAN SMIT TER ON
CARRIER DETECT
TEST MODE
A
L
A
R
M F
A
U
L
T ENTER
CLEAR
TO MULTIPLEXER
INTERFACE I/O
TO J10
100 PIN
SHIELDED RIBBON
CABLE
8 CHANNEL MULTIPLEXER
APPLICATION
Figure 2-2. UB-54 to SDM-300 Interconnection Diagram
5. (Used with DEMUX only) Connect the breakout panel to the SDR-54
Demodulator using three standard 25-pin interface cables conforming to Tables
2-13, 2-14, and 2-15 as shown in Figure 2-3.
TRIB 1 DATA TRIB 2 DATA TRIB 3 DATA TRIB 4 DATA TRIB 5 DATA TRIB 6 DATA TRIB 7 DATA TRIB 8 DATA AUX
J9 J 8 J 7 J4 J1 J2 J3 J5 J6
MUX / DEMUX
BREAKOUT
UB-54
SDR-54
POWER FAULT CARRIER
DETECT
ANTENNA
ALIGNMENT
LNB
POWER
M & C
REMOTE
SATELLITE DATA
RECEIVER
STATUS
J6 J5 J4
J13 J12
TO RX
AGGREGATE J11
UB-54
SDR-54 W/ INTEGRATED
8 CHANNEL DEMULTIPLEXER
DEMUX
TRIBS 5-8
DEMUX
TRIBS 1-4
8 CHANNEL DEMULTIPLEXER
APPLICATION
Figure 2-3. UB-54 to SDR-54 Interconnection Diagram
6. If problems exist with the installation, contact Comtech EFData Customer
Support for additional information.