Comtech EF Data CLC-10 - Manual (Page 25)

CLC-10 Comtech LPOD Controller Handheld Terminal M&C Accessory Revision 3
Setup MN-CLC10
2–5
2.2.2.2 Circular Connector Connection for 1:1 Redundancy Applications
Before proceeding, you should review Appendix A. 1:1 REDUNDANCY in Comtech EF
Data’s LPOD Outdoor Amplifier / Block Up Converter (BUC) Installation and
Operation Manual (CEFD P/N MN-LPOD) or the SPOD Outdoor Amplifier
Installation and Operation Manual (CEFD P/N MN-SPODPSX).
Figure 2-8. CA-0020526 Cable Connection for SSPA 1:1 Redundancy System
Connect the CA-0020526 Serial Interface Cable’s 19-pin circular connector to the Redundant
Loop Cable Assembly ‘J1’ receptacle as shown in Figure 2-8.
2.3 1:1 Redundancy Applications – Cabling Requirements
Figure 2-9 and Figure 2-10 show the SSPA 1:1 Redundancy System cabling requirements.
See Figure 2-8 for an example of the CA-0020526 -to- Redundant Loop Cable Assembly User
M&C ‘J1’ connection.