Converter i/o modules, Spare, D.2.4 converter i/o modules – Comtech EF Data UT-4579 User Manual
Page 95: D.3 spare, Spare 79, D.3 s, D.2.4 c, I/o m
UT4579 X-Band Up Converter
MN/UT4579.IOM
Maintenance and Troubleshooting
Rev. 0
79
D.2.4 C
ONVERTER
I/O M
ODULES
The Converter I/O Modules (IOM, or TSM) are installed on the rear panel of the
converter. The screws holding the I/O Module to the converter chassis are installed
“hand tight”.
IMPORTANT
When installing an I/O Module “DO NOT” use a screwdriver to tighten the module
mounting screws - install screws “hand tight” only.
D.3 S
PARE
Comtech EF Data recommends field maintenance replacement at the RF converter level,
and that the converter be returned to Comtech EF Data for repairs. However, for field
replacement of the converter modules, the following is a list of recommended spare.
Contact Comtech EF Data for the correct spares for and particular converter.