Comtech EF Data CDM-570/570L Vipersat - Manual (Page 40)

Menu Descriptions
3-4 Vipersat CDM-570/570L User Guide
Figure 3-2 Administration screen
Ensure that the Working Mode is set to Router-Vipersat.
If it is not, enter C at the command prompt and change the setting by selecting
4, as shown in figure 3-3. The unit will automatically reboot in order to imple-
ment the change for this setting.
Figure 3-3 Working Mode dialog
Note: If the Router-Vipersat option does not appear as a selection, the Vipersat
Feature Code has not yet been entered into this unit. Input the Vipersat
code as described in the next section.
From the Administration menu, enter an F at the prompt to display the Feature
Configuration screen shown in figure 3-4.
NOTE