ConnectGear WA660N - Manual (Page 45)

38
Here are descriptions of every setup item:
Band
Please select the wireless band you wish to use. By
selecting different band setting, you’ll be able to
allow or deny the wireless client of a certain band.
If you select 2.4GHz (B), 2.4GHz (N), or 2.4GHz
(G), only wireless clients using the wireless band
you select (802.11b, 802.11 Draft-N, or 802.11g)
will be able to connect to this access point.
If you select 2.4GHz (B+G), then only wireless
clients using 802.11b and 802.11g band will be
able to connect to this access point.
If you want to allow 802.11b, 802.11g, and 802.11
Draft-N clients to connect to this access point,
select 2.4GHz (B+G+N).
MAIN SSID Please input the ESSID (the name used to identify
this wireless access point) here. You can input up
to 32 alphanumerical characters. PLEASE NOTE
THAT ESSID IS CASE SENSITIVE.
Multiple ESSID The access point supports multiple SSID function;
up to four SSIDs can be set. If you want to
configure additional SSIDs, please click this
button. For detailed descriptions of the function,
please refer to Section 2-4-1-1.
Channel Number Please select a channel number you wish to use.
The channel number must be same with another
wireless access point you wish to connect
Associated Clients Click ‘Show Active Clients’ button and a new
popup window will appear which contains the
information about all wireless clients connected to
this access point. You can click ‘Refresh’ button in
popup window to keep information up-to-date
Root AP SSID In ‘Universal Repeater’ mode, this device can act
as a station to connect to a Root AP. You should
assign the SSID of the Root AP here or click